17
Install the new gelstring
Note: Use gaffer's tape to attach the gelstrings to the rollers. Do not use duct tape or
masking tape.
1. Put a strip of gaffer's tape on the edge of the gelstring trailer.
Holding the trailer, let the rest of the roll hang off the right side of
the color changer.
2. Center the edge of the trailer between the two ends of the left
roller as shown to the left. Tape the trailer along the top of the
roller as shown.
3. Roll the gelstring onto the left roller until the end of the leader is
directly above the right roller.
4. Put a strip of gaffer's tape on the gelstring leader.
5. While holding the end of the gelstring, turn the right roller toward
the left roller. The sticker at the bottom end of the roller has a
black line on it to help you judge the number of turns.
6. Tape the gelstring to the right (spring) roller.
Note: Use maximum number of spring roller turns for gel strings with maximum number
of frames. Use less turns for shorter gelstrings. Refer to the gelstring tension chart
below for the exact number of turns for your color changer/gelstring combination.
Models: 15010, 16080, 16090, 16100,
and 5000
Comments to this Manuals