Wybron Coloram II User Manual download pdf (Page 10)

The Coloram II Power Supply is designed to be free standing, truss mounted, or rack

mounted. You decide which mounting method best suits your application.

The power supply comes with a mounting bracket which hooks over the pipe or truss of

your lighting rig and is then locked into place with a thumb screw. If you have selected

this mounting method, connect the safety cable by running it around the pipe or truss to

which the power supply is attached.

The power supply can also be mounted into a 19" rack using the optional Coloram II

Power Supply rack mount kit. The rack mount kit will accommodate two Coloram II

Power Supplies side by side.

4. Connect the color changers to the power supply

Connect the color changers to the power supply using 4-pin Wybron Power/Data cable.

Refer to the HEAD-FEET RESTRICTION section of the manual for details of the length

of cable runs.

5. Connect the power supply to AC power

Plug the AC cord into a non-dimmed power circuit. The power supply automatically

accommodates 100 - 132 VAC (50/60 Hz) or 170 - 240 VAC (50/60 Hz).

Power at the Coloram II (RAM) Power Supply is indicated by a red LED display which

can be viewed from the stage. Power is also indicated on the bottom of each color

changer by a red or yellow LED.

The connected color changers will automatically "calibrate" themselves to the gel string

installed by doing the following actions:

a. Moving the gel string toward the last frame, in search of the

long foil tag.

b. Turning around at the long foil tag and then searching for the

short foil tag at the beginning of the gel string.

c. Stopping at the short foil tag and staying there if no DMX

signal is present or going to it's commanded position if DMX

signal is present.

Note: It may take up to 30 seconds before all color changers start to initialize. Upon

power up, the power supply will scroll a short message which includes the software

version installed in it. The power supply will then initiate a "roll call" which tells the color

changers to initialize.

Caution: Do not power the Coloram II (RAM) Power Supply from a dimmer.

Severe damage will result and is not covered by product warranty.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

No comments

Wybron Coloram II User Manual Page 10