Wybron Coloram II User Manual download pdf (Page 16)

Replacing a gelstring

At some point in time you may find that you need to replace the gelstring in your color

changer, either because the old one wears out or because you want a different

selection of colors. With all the Coloram II Color Changers this is quick and easy.

Caution: Operating the Coloram II Color Changers with damaged

gelstrings will damage the color changers. Replace the gelstrings before

damage occurs.

Note: If a frame in the gelstring becomes damaged, do not remove the frame and splice

the gelstring. Replace the gelstring. Gelstrings may be ordered from Color Express by

WYBRON INCORPORATED.

Remove the old gelstring

This procedure is performed with no power to the color changer.

1. Place the color changer on a flat surface with the Coloram II logo

facing up.

2. Remove the front panel by unscrewing the two thumb screws at the

top right and left corners of the front door as shown in the first

picture on the left.

3. Gently roll the gelstring onto the left roller, exposing the clear leader

taped on the right roller.

4. Untape the leader from the right roller. Remove the tape from the

leader.

5. Roll the gelstring onto a cardboard tube as you slowly remove it

from the left roller.

6. When you reach the clear trailer, untape it from the roller.

Hint: To save time, move all gelstrings to the first frame via the DMX

source before disconnecting power.

Thumb screws

Figure 13

Figure 14

Left roller

(Drive roller)

Right roller

(Spring Roller)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

No comments

Wybron Coloram II User Manual Page 16