Wybron Transition Optic User Manual download pdf (Page 15)

Service

Lamp Replacement

DANGER: Disconnect fixture from line voltage before replacing

lamp.

WARNING: Lamp and lamp mounting surfaces are hot! Allow lamp to

cool before replacing.

 Disconnect fixture from AC power.

 Remove lamp plate by removing mounting screws as shown in figure

1.1 and pull lamp assembly straight back from reflector.

 Grasping lamp by the base remove old lamp from the socket.

CAUTION: Touching the glass lamp envelope can reduce lamp life.

Handle new lamps with a clean cloth. Fingerprints can be

cleaned off lamp envelope with alcohol and a clean cloth.

 Insert new lamp into base. Lamp is fully seated when spring clips snap

over lamp base.

Cleaning the Reflector

WARNING: To avoid burns or damage to the fixture, allow fixture to

cool before cleaning.

 Remove Transition lid.

 Remove lamp plate by removing mounting screws as shown in figure

1.2 and pull lamp assembly straight back from reflector.

 Remove top two reflector mount screws and washers.

 Lift reflector up and back to remove from fixture.

 Use clean pressurized air or a soft cloth with alcohol to clean the

reflective surface.

 Reseat the reflector and secure in place by replacing the top screws

and washers.

 Replace lamp plate and lid.

CAUTION: Harsh chemicals and rough cloth can damage the cold

mirror coating on the reflector. Replace damaged

reflectors.

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Wybron Transition Optic User Manual Page 15