Wybron Transition Optic User Manual download pdf (Page 10)

Fixture Setup and Configuration

Installing the Lamp

DANGER: Disconnect fixture from line voltage before replacing

lamp.

CAUTION: Lamp and lamp mounting surfaces are hot! Allow lamp to

cool 10 minutes before replacing

Lamp Specifications

Lamp socket / base: G22

Part#

UHI-S150DW/A/UVP Lamp, Eurospot UHI Series 3000K 150W

UHI-S150DM/A/UVP Lamp, Eurospot UHI Series 4200K 150W

CDM150/T6/830 Lamp, CDM 150W with UV Fade Block 3000K

CDM150/T6/942 Lamp, CDM 150W with UV Fade Block 4200K

Figure 1.1

 Disconnect fixture from AC power.

 Remove lamp plate by unscrewing mounting screws and pulling the

lamp assembly straight back from the illuminator.

 Grasping lamp by the base remove old lamp from the socket.

 Insert new lamp into base. Lamp is fully seated when spring clips snap

over lamp base.

CAUTION: Touching the glass lamp envelope can reduce lamp life.

Handle new lamps with a clean cloth. Fingerprints can

be cleaned off the lamp envelope with alcohol and a

clean cloth.

Locating the Fixture

The Transition CMY fiber illuminator is designed to be surface mounted,

located in a cabinet or closet, or hung from mounting pipe with the optional

pipe bracket.

Surface Mounting

The Transition may be surface mounted on a hard surface table,

counter top, or floor (wood, laminate, metal, tile).

Do not mount the Transition on soft surfaces such as carpet, linoleum,

cushions, or fabric.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

Wybron Transition Optic User Manual Page 10